I decided after work to finally install the chainguard I got from Velo Orange a year or so ago. It was as difficult as I imagined. I was kind of limited to TA cranks with the small diameter of cutout(they have since made one that accepts more variety or cranks- with a larger hole). The original Porteur bicycles with steel cottered cranks were offset to allow for clearance so neither the crank arm or the chainring would rub against the guard. I created a “spacer” to move the position of the chainring over a little, away from the chainguard, out of a Lambert outer chainring. The mounting brackets were fabricated at Via Bicycle(I bought the chainguard without any hardware). After about 2 hours of work, I had it mounted and it did not rub, but it was a lot of measuring and was a bit of work to put it into the proper position so it would not rub. I noticed, after the final tightening, that the chainring is not center into the cutout hole. That sucks. But that is the position where it does not rub, so. . . where it will stay.
More info on Porteur bicycles here on Joel Metz’s website
a chainguard mounted on a Bilenky Porteur owned by my friend Pat built by Bilenky Cycles. It is 9th Bilenky he has had built. the Pinstriping was done by Simon Firth at Bilenky Cycles, he is really coming into his own with it. (as you can see, some rubbing. I assume my might end up like this too. well I hope not).